SelectForm® Model 450 Series Swaging Tools
Pressures Up to 15,000 psi (1,034 bar)
The patented SelectForm® Model 450 Series Swaging Tool is designed to swage a tube into a tube header by forming two beads, one on each side of the header, thus expanding and locking the tube into place. The amount of swaging is controlled by limiting the travel of the expanding die. The tool's integral stroke adjuster provides easy wrench adjustment of piston stroke, this lets the operator fine tune the amount of tube expansion desired.
The Model 450 Series Tool handles standard and metric tube, pipe, and fitting sizes from 0.62 in. to 3.50 in. OD (15.7 mm to 88.9 mm OD) in diameter. For each specific tube outside diameter, the tool can accommodate a range of wall thicknesses.
Contact Airmo for special tool sizes and configurations.
SelectForm® Model 450 Series Swaging Tools.pdf
SelectForm® Product Line Card.pdf
Applications
The SelectForm® Model 450 Series Tool is used for a variety of swaging applications.
Model 450 Tool Applications |
Tube-to-header
|
Ferrule attachment |
Fitting attachment |
Tube-to-baffle plates
|
Piece-to-piece attachment |
SelectForm® End Forming Systems
SelectForm® Model 400 Hydraulic Power Packs - Pressures up to 3,000 psi (207 bar)
ExpanTek® Expansion Systems
ExpanTek® Model HPS Hydro-Expansion Systems - Pressures up to 20,000 psi (1,379 bar)
NuQuip® High-Pressure Accessories
NuQuip® Model QD Series High-Pressure Quick Disconnects - Pressures up to 60,000 psi (4,137 bar)
Top of page
Contact Airmo for Your System and Tool Needs |